Knowledge

Electrosurgery, by contrast, uses radio frequency (RF) alternating current to heat the tissue by RF induced intracellular oscillation of ionized molecules that result in an elevation of intracellular

Electrosurgery is the application of a high-frequency (radio frequency) alternating polarity, electrical current to biological tissue as a means to cut, coagulate, desiccate, or fulgurate tissue. (The

The electrosurgical plates (return electrodes, electrosurgical pads) are a cost effective, single patient use which can be used in any procedure. Provides consistent thermal distribution, conforms to

Single-use Neutral Electrode Grounding Pads (Diathermy Pads / Neutral-Electrodes) for electrosurgery. All the Neutral Electrode Grounding Pads are made of 1mm PE-Foam and contain a medical grade acryl

Electric bistoury neutral electrode which can be reused with an independent disposable conductor gel formed by a sheet of adhesive conductor gel which optimizes the contact with the patient skin and w

Protective earth resistance Earth leakage current Touch current (formerly enclosure leakage current) Patient leakage current Patient auxiliary current Mains on applied part (MAP) Jinhua Huacheng Medic

IEC60601 AAMI/NFPA 99 The primary standard for medical devices is IEC 60601. General requirements for protection against electric shock hazards are covered in IEC 60601.1, Section 3. In this standard,

To help verify the functionality and safety of medical devices, electrical safety standards have been established in the United States, European countries, and other parts of the world. The standards

Basic electrical safety tests include: Visual inspection of cables, plugs and connectors Measurement of ground wire resistance Measurement of chassis and patient lead/contact isolation Electrical safe

Electrical safety takes on added significance in electrically-susceptible patients. For cardiac procedures, electrically-conductive catheters may be placed into the heart while the patient is connecte

Electro-Medical Devices are powered by the mains or an internal power source (batteries) and often attached to the patient by wires. Some of these devices have active parts inserted into the patient b

a. Frequency range: 0MHz~1.0MHz； b. Maximum output current：1A； c. Cable length：3m； d. Load impedance：non-electric resistant impedance -- 200 Ώ. e. The electrode adopts Stainless materials , Connecting